HOW TO APPLY LARGE STICKERS WITH TRANSFER PAPER

Step 1: Prepare Surface and
Decal

Use a damp cloth to clean the surface of any residue
or dust particles. This is important to ensure vinyl
adhesion. If the surface has recently been painted,
you need to allow the paint to cure for at least 2
weeks before installing the decal. Unroll decal and
lay on flat hard surface. Use squeegee or credit card
covered with soft fabric or lint free cloth on both
sides of the decal to smooth out any wrinkles. If the
decal will not lay flat, you can weigh it down with
books overnight.

Step:2 Position Decal on Surface

Use painter’s tape or masking tape on the corners of the decal. Make sure the
decal is placed in the desired position. Use a level or tape measure to make
sure the decal is straight. When the decals is level and in correct position, use
one long strip of tape and place it down the middle (shortest distance) of the
decal to create a hinge.

S t e p : 3 T r a n s f e r D e c a l t o S u r f a c e

With the decal taped to the surface, detach one side of the decal. Fold the
decal over the centre line and carefully peel back the backing paper then cut
away the backing paper. Take your time and do not rush the process. Using a
felt squeegee or credit card (wrapped in a soft fabric) in a smooth sweeping
motion moving from the centre out push the decal against the surface.
Remember to work from the centre outwards to avoid any bubbles. After
finished with one side, remove the centre tape line and repeat the process
with the other side. If you are applying to a rough surface, you may need to
wrap the squeegee in a soft cloth for better application and to avoid scratching
the print.

S t e p : 4 R e m o v e T r a n s f e r T a p e

With the decal taped to the surface, detach one side of the decal. Fold the
decal over the centre line and carefully peel back the backing paper then cut
away the backing paper. Take your time and do not rush the process. Using a
felt squeegee or credit card (wrapped in a soft fabric) in a smooth sweeping
motion moving from the centre out push the decal against the surface.
Remember to work from the centre outwards to avoid any bubbles. After
finished with one side, remove the centre tape line and repeat the process
with the other side. If you are applying to a rough surface, you may need to
wrap the squeegee in a soft cloth for better application and to avoid scratching
the print.

S p e c i a l c o n s i d e r a t i o n s

Weather: In extreme weather conditions vinyl might not apply as well on
exterior walls or in places like a garage or tool shed. Vinyl applies best in
temperatures between 15 °C - 25 °C degrees. If the surface is too cold, vinyl
will not stick well and may cause the vinyl to tear. If the surface feels cold you
may want to warm up first. If the surface is too hot or in direct sunlight the
decal may be too sticky and become difficult to install or ruin the decal.
Wall Texture: Decals may not stick well to highly textured surfaces. To achieve
the best adhesion possible on a textured surface, use your fingers or a soft
cloth to very gently run the decal into the grooves of your texture